Weber Genesis E-320 LP Owner Manual - Page 15

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS ƽ DANGER MAIN BURNER MANUAL LIGHTING When the "excess gas flow control" feature is activated, a small amount of gas is still flowing to the burners. After turning OFF the cylinder and burner control knobs, wait at least 5 minutes for the gas to clear before attempting to light the barbecue. Failure to do so may result in an explosive flame-up, which can cause serious bodily injury or death. 2 ARRE TE /OFF APAGAD O 1 1 5 3) Turn the cylinder on by turning the cylinder valve counterclockwise. 4) Insert match holder with lit match into the matchlight hole in the front of the cooking box. ƽ WARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue. 5) Push BURNER 1 control knob down and turn to START/HI. 6) Check that the burner is lit by looking through the matchlight hole on the front of the cooking box. You should see a flame. ƽ WARNING: If the burner does not light in five seconds, turn the Burner 1 control knob to OFF and wait 5 minutes to let the gas clear before you try again. 7) After BURNER 1 is lit you can turn on BURNER 2 and BURNER 3. Note - Always light BURNER 1 first.The other burners ignite from BURNER 1. 46 3 TO EXTINGUISH Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply OFF at the source. *The grill illustrated may have slight differences than the model purchased. 15 15 2 7 5 LIGHTING THE SIDE BURNER ƽ DANGER Failure to open the lid while igniting the side burner, or not waiting 5 minutes to allow the gas to clear if the side burner does not light, may result in an explosive flame-up which can cause serious bodily injury or death. ƽ WARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. 1) Open the side burner lid. 2) Check that the side burner valve is turned off (Push control knob in and turn clockwise to ensure that it is in the "OFF" position), turn all burners not being used to the "OFF" position (push in and turn clockwise). 3) Turn the gas supply valve on. 4) Push down and turn the side burner control valve to "HI". 5) Press the igniter button several times so it clicks each time. ƽ CAUTION: Side burner flame may be difficult to see on a bright sunny day. ƽ WARNING: If the side burner does not light in five (5) seconds: a) Turn off the side burner control valve, main burners and gas supply at source. b) Wait 5 minutes to let the gas clear before you try again, or try lighting with a match (see "Manually Lighting the Side Burner"). 320 WWW.WEBER.COM®