Weber Genesis Gold C NG Owner Manual - Page 26
Side Burner Troubleshooting
View all Weber Genesis Gold C NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Side Burner Troubleshooting ƽ WARNING: Before attempting any troubleshooting steps, all gas controls and supply valves should be in the OFF position. Problem Side Burner does not light. Check Is gas supply off? Cure Turn supply on. Flame is low in HIGH position. Is the fuel hose bent or kinked? Straighten hose. Flame is very yellow in conjunction with the smell of gas, OR Inspect the Weber Spider Stopper Guard for possible obstructions. (lockage of holes.) Burner makes popping noise in conjunction with the smell of gas. Clean Weber Spider Stopper Guard. (See section "Annual Maintenance") Push button ignition does not work. Does burner light with a match? If match lights burner, checkigniter (see below). Side Burner maintenance ƽ WARNING: All gas controls and supply valves should be in the OFF position. Check igniter: Remove side burner cover. To remove side burner cover, remove control knob and screws that hold cover to bottom(1). (1) 1) Igniter 2) Igniter Wire 3) Venturi/Burner 4) 1/8 to 3/16 inch gap between electrode and burner (4) (3) Make sure wire is connected between igniter and electrode. Check that igniter lock nut is tight. Note: If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. Adjust igniter electrode to burner. Gap should be 1/8 to 3/16 inch from tip of electrode to burner. Spark should (1) (2) be a white/blue color, not yellow. D-10