Weber Summit Platinum B4 NG Owner Manual - Page 32

32 MAINTENANCE CROSSOVER® IGNITION SYSTEM OPERATIONS If the Crossover® ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover® ignition system. • Check that both ignition wires(1,2) are attached properly. • Check that the Crossover® ignition button is activating. • You should hear the igniter sparking. If the Crossover® ignition system still fails to light, contact the Customer (1 ) Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. (2 ) REPLACE IGNITER BATTERIES Parts required: 1 AA alkaline battery per igniter. Unscrew igniter button from bottom of control panel. Remove igniter button and contact spring. Remove old battery and replace with a new AA alkaline battery. Positive end(1) of battery faces up as shown in illustration. Replace spring contact(2) and screw igniter button(3) back down. ƽ ATTENTION: This product has been safety tested and is only certified for use in a specific country. Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-Stephen Products Co. replacement part(s) information. ƽ WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting Weber-Stephen Products Co., Customer Service Department. Your actions, if you fail to follow this product Warning, may cause a fire or an explosion resulting in serious personal injury or death and damage to property.