Weber Summit Platinum B6 LP Owner Manual - Page 30
Main And Smoker Troubleshooting
View all Weber Summit Platinum B6 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
30 MAIN AND SMOKER TROUBLESHOOTING PROBLEM Burners burn with a yellow or orange flame, in conjunction with the smell of gas. CHECK Inspect Spider / Insect Screens for possible obstructions. (Blockage of holes.) Burners do not light. -or- Burners have a small flickering flame in the HIGH position. -orBarbecue temperature only reaches 250˚ to 300˚ in the HIGH position. The excess flow safety device, which is part of the barbecue to cylinder connection, may have activated. Burner does not light, or flame is low Is LP fuel low or empty? in HIGH position. Is fuel hose bent or kinked? CURE Clean Spider / Insect Screens. (See Section "Annual Maintenance") To reset the excess flow safety device turn all burner control knobs and the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner control knobs OFF. Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting Instructions". Refill LP cylinder. Straighten fuel hose. Experiencing flare-ups: ƽ CAUTION: Do not line the bottom tray with aluminum foil. Does the Left burner light with a match? If you can light the Left burner with a match, then check the Crossover® ignition system. Are you preheating barbecue in the prescribed manner? All burners on high for 10 to 15 minutes for preheating. Are the cooking grates and Flavorizer® bars heavily coated with burned-on grease? Clean thoroughly. (See Section "Cleaning") Is the bottom tray "dirty" and not allowing Clean bottom tray grease to flow into catch pan? Burner flame pattern is erratic. Flame is low when burner is on HIGH. Flames do not run the whole length of the burner tube. Are burners clean? Inside of lid appears to be "peeling." (Resembles paint peeling.) The lid is stainless steel, not paint. It cannot "peel". What you are seeing is baked on grease that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean burners. (See Section "Maintenance".) Clean thoroughly. (See Section "Cleaning".) If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.