Weider 175 Bench English Manual - Page 6

Assembly Before beginning assembly, carefully read the following information and instructions: Make Things Easier for Yourself! Everything in this manual is designed to ensure that the assembly of our products can be completed successfully by anyone. However, it is important to recognize that your new equipment is a sophisticated product with many small parts and consequently, the assembly process will take time. Most people find that by setting aside plenty of time, and by deciding to make the task enjoyable, assembly will go smoothly. ¥ Assembly requires two people. ¥ Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. ¥ Tighten all parts as you assemble them, unless instructed to do otherwise. ¥ For help identifying the small parts, use the PART IDENTIFICATION CHART on page 5. ¥ As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. The following tools (not included) are required for assembly: ¥ Two (2) adjustable wrenches ¥ One (1) rubber mallet ¥ One (1) standard screwdriver ¥ One (1) phillips screwdriver ¥ Lubricant, such as grease or petroleum jelly plus soapy water. Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches or a set of ratchet wrenches. 1. Before assembling this product, make sure you 1 understand the information in the box above. Press a 2Ó Square Inner Cap (17) into the top end of one Upright (1). Press a 2Ó Square Inner Cap (17) into each end of the Right Stabilizer (26). Insert three M10 x 62mm Carriage Bolts (33) through the holes in the Right Stabilizer (26). Note: On one side of the Stabilizer there is an indentation around the holes. Insert the Bolts from this side. Place the Stabilizer flat on the floor. Place the Upright (1) over the three M10 x 62mm Carriage Bolts (33) in the Right Stabilizer (26). Secure the Upright with three M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet. Note: Set the Upright aside and make sure it cannot fall over. 17 1 11 11 17 26 17 33 33 6