Weider Club 16.4st English Manual - Page 7
Slide the Leg Press Seat Frame 79 onto
View all Weider Club 16.4st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Press a 2Ó Square Inner Cap (27) into the end 4 of the Top Frame (55). Press a 1 3/4Ó Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two 1Ó Round Inner Caps (75) into the top of the crossbar. 27 Attach the Top Frame (55) to the Rear Upright (74) and the Leg Press Upright (56) with two 5/16Ó x 2 3/4Ó Bolts (11) and two 5/16Ó Nylon Locknuts (3). Attach the Top Frame (55) to the Front Upright (42) with two 5/16Ó x 2 3/4Ó Bolts (11), 11 two 5/16Ó Flat Washers (8), and two 5/16Ó Nylon Locknuts (3). 55 11 75 8 44 3 44 Crossbar 56 74 3 42 FRAME ASSEMBLY 5. Slide the Leg Press Seat Frame (79) onto the indicated 5/16Ó x 2 1/2Ó Carriage Bolts (1) in the Stabilizer (5). Hand tighten two 5/16Ó Nylon Locknuts (3) onto the Carriage Bolts. Attach the other end of the Leg Press Seat Frame (79) to the Leg Press Upright (56) with two 5/16Ó x 2 3/4Ó Bolts (11), two 5/16Ó Flat Washers (8), and two 5/16Ó Nylon Locknuts (3). Attach the Handle (82) to the Leg Press Seat Frame (79) with two 5/16Ó x 2 1/2Ó Carriage Bolts (1) and two 5/16Ó Nylon Locknuts (3). Tighten all Nylon Locknuts used in steps 1Ð5. 5 56 8 3 1 79 11 3 3 1 82 5 6. Set two Weight Bumpers (19) on the bracket on the Base (4) as shown. Set two Weight Bumpers (19) on the bracket on the Stabilizer (5). Stack eight Weights (25) onto each set of Weight Bumpers (19). Be sure that the pin grooves are all on the same side of each stack of Weights. Be careful not to tip either stack of Weights (25) until step 8 is complete. 6 Pin Grooves 25 25 19 5ÑBracket 4ÑBracket Pin Grooves 19 7