Weider Max By Xp400 English Manual - Page 14

ATTACHING THE ACCESSORIES With a high pulley attached to the resistance system (see ATTACHING THE HIGH PULLEYS AND LEG LEVER on page 13), attach a Short Handle (49) to the Short Cable (33) with a Cable Clip (51). The Short Handles (49), Long Handles (not shown), or Ankle Strap (not shown) can be attached to the Long Cable (80) with a Cable Clip (51). Attach the Curl Bar (8) to the Leg Lever (7) with a Cable Clip. Attach the Leg Press Strap (not shown) to both ends of the Long Cable, or the lat bar to the Short Cables (33), with two Cable Clips. ADJUSTING THE RESISTANCE To add resistance, hold a "U"-channel on the 10pound Center Resistance Bar (44) firmly and push the end of a resistance bar under it. Repeat with the other end of the resistance bar. If more resistance is needed, add one resistance bar at a time. Note: When adding resistance, always start with the heaviest resistance bar to be used, and finish with the lightest resistance bar. When removing resistance bars from the "U"-channels, start with the lightest resistance bar and finish with the heaviest. WARNING: When adding resist- ance, make sure that both ends of the resistance bar rest under the two "U"-channels. The rings on the Removable Resistance Bars (36, 67) must be pushed against the Tray (35). Do not add or remove resistance bars from the "U"-channels while the end of the Long Cable (80) is pulled out. Note: The resistance system uses progressive resistance. As the resistance bars begin to bend, the amount of resistance will increase gradually. As the resistance bars bend further, the resistance will increase rapidly. Additional resistance can be added to the resistance system by calling toll-free 1-877-992-5999 and asking for model number WEMC0642 (100-pound MAX PACK) or WEMC0942 (200-pound MAX PACK). 33 51 49 80 "U"-Channel 67 Resistance Bars 35 36 44 "U"-Channel 80 14