Weider Pro 230 Bench English Manual - Page 8
Weider Pro 230 Bench Manual
View all Weider Pro 230 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
10. Pull the Moment Arm (10) forward. Hold the lower end of the Left Press Arm (52) in the upper end of the Moment Arm. The Left Press Arm must be tumed so the Handle (12) is on the side shown. Attach the Left Press Arm with two 3/8" x 2 1/2" Bolts (44) and two 3/8" Nylon Locknuts (33). The Bolts must be inserted from the side shown, or the BODYLIFT will not function properly. Press a Small Bumper (91) onto the underside of the Handle (12). Assemble the Right Press Arm (11) in the same manner. 11. Insert the 1/4" x 2 1/2" Carriage Bolt (46) into the Seat Bracket (38). Attach the Seat Bracket to the Seat (14) with the two 1/4 x 3/4" Screws (47). Insert the 1/4" x 2 1/2" Carriage Bolt (46) into the indicated hole in the Seat Frame (8). The narrow end of the Seat must be facing the curved end of the Seat Frame. Tighten a 1/4" Nylon Jam Nut (55) with a 1/4" Flat Washer (40) onto the Carriage Bolt. Attach the other end of the Seat to the Seat Frame with a 1/4" x 2 1/2" Screw (32) and a 1/4" Flat Washer (40). 12. Attach the Seat Frame (8) to the Front Upright (7) with the 5/16" x 2 3/4" Bolt (78) and a 5/16" Nylon Locknut The Moment Arm (1n) must be in front of the indicated tube on the Seat Frame. Attach the Seat Braces (21) to the Seat Frame (8) with a 3/8" x 2 3/4" Bolt (85) and a 3/8" Nylon Locknut (33). Tighten the Nylon Locknuts on both ends of the Seat Braces. 10 11 10 3 0 11 14 00 Oa 4 44 12 91- * 7 52 46 Narrow End 47 0 ,4 32-4 • e 55 12 ( 1 73 33 Tube 78 13. Hold the Cable (25) under the indicated 3 1/2" Pulley (27). Hold the 1/2" x 1" Sleeve (89) between the small holes in the lower end of the Leg Lever (9). Attach the Sleeve with the 1/4" x 1 3/4" Bolt (43) and a 1/4" Nylon Jam Nut (55). The Cable must be between the Pulley and the Sleeve. 8 10 **_ 13 9 27 55- . . 0 8 1 OI 25 • O 9 8