Weider Pro 265 Bench English Manual - Page 7

2. Attach the Bench Frame (1) to the Front Leg (2) 2 with two M10 x 65mm Bolts (40), two M10 Washers (44), and two M10 Nylon Locknuts (43). Do not tighten the Nylon Locknuts yet. 40 1 44 43 40 2 3. Attach the Bench Frame (1) to the Crossbar (4) 3 with two M10 x 81mm Bolts (41) and two M10 Nylon Locknuts (43). Tighten the M10 Nylon Locknuts (43) used in steps 1 through 3. 4 43 41 41 1 4. Attach the Weight Tube (16) inside the Leg Lever 4 (3) with an M8 x 58mm Bolt (52), two M8 Washers (56), a 10mm Spacer (32), and an M8 Nylon Locknut (55). Press the 25mm Round Angled Cap (28) onto the Weight Tube (16). Grease an M10 x 68mm Bolt (54). Attach the Leg Lever (3) with the Bolt and an M10 Nylon Locknut (43). Do not overtighten the Nylon Locknut; the Leg Lever must pivot easily. 43 2 3 55 32 28 56 56 16 52 Grease 54 5. Orient the Backrest Frames (12) with the indicated tubes in the position shown. Attach the Backrest Frames to the Backrest Bracket (10) with four M6 x 40mm Bolts (49), four M6 Washers (48), and four M6 Nylon Locknuts (51). Do not tighten the Nylon Locknuts yet. 5 49 48 12 48 Tubes 51 12 48 48 49 51 10 7