Weider Pro 8000 Uk Manual - Page 20

52. Wrap the Right Stack Cable (68) around a 90mm 52 Pulley (39). Attach the Pulley and a Small Cable Trap (48) to the Right Top Frame (7) with an M10 x 110mm Bolt (73) and an M10 Nylon Locknut (114). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 53. Route the Right Stack Cable (68) down through 53 the Right Top Frame (7) and over a 90mm Pulley (39). Attach the Pulley inside the Top Frame with an M10 x 80mm Bolt (111), two M10 Washers (116), two 19mm Spacer (77), and an M10 Nylon Locknut (114). Make sure the Cable Trap is ori- ented to hold the Cable in the groove of the Pulley. 54. Set an M12 Washer (129) on top of the Long 54 Weight Tube (36). Thread an M12 Nut (128) all the way onto the Right Stack Cable (68). Thread the Right Stack Cable (68) into the Long Weight Tube (36). Tighten the M12 Nut (128) against the M12 Washer (129). 73 48 39 68 7 114 114 77 116 77 116 111 7 68 39 68 128 129 36 55. Locate the Press Cable (69). Grease the shoulder of an M8 x 86mm Shoulder Bolt (86). Attach the Cable to the Leg Press Frame (12) with the Bolt, an M8 Washer (117) and an M8 Nylon Locknut (115). Make sure that the Cable can pivot easily around the shoulder of the Bolt. 56. Wrap the Press Cable (69) around a 90mm Pulley (39). Attach the Pulley, two Half Finger Guards (42), a Small Cable Trap (48), and an M10 Washer (116) to the Left Seat Frame (10) with an M10 x 103mm Bolt (106), an M10 Washer (116), and an M10 Nylon Locknut (114). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 55 117 69 86 115 12 56 114 116 10 42 48 42 69 106 39 116 20