Weider Pro 9450 Uk Manual - Page 11
Cable Assembly
View all Weider Pro 9450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
15. See the inset drawing. Attach the Military Press Arm 15 (84) to the Pivot Arm (80) with two 5/16" x 2 1/4" Bolts (33) and two 5/16" Nylon Locknuts (3). Press two 1 1/2" Square Inner Caps (32) into the indicated end of the Military Press Arm (84). Press two 1" Round Inner Caps (49) into the Military Press Arm. 21 Attach the Pivot Arm (80) to the Rear Upright (74) with a 3/8" x 3 1/4" Bolt (67) and a 3/8" Nylon Locknut (21). 74 32 49 32 84 80 67 56 33 80 CABLE ASSEMBLY 16 16. Locate and open the parts bags labelled "CABLE ASSEMBLY" and "PULLEYS." During steps 16 through 36, refer to the CABLE DIAGRAMS on pages 25 and 26 of this manual to verify proper cable routing. Before beginning this section, fully unwind the four Cables. Identify the four Cables by comparing the lengths and ends of the Cables. The approximate length of each Cable is listed (in inches) after the key number in the drawing. IMPORTANT: Whilst assembling the cables, do 17 not over tighten the bolts and nuts attaching the pulleys; the pulleys must be able to turn freely. 21 17. Locate the High Cable (58). Wrap the High Cable around a 3 1/2" Pulley (15). Attach the Pulley to the Top Frame (55) with a 3/8" x 3 3/4" Bolt (88) and a 3/8" Nylon Locknut (21). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the hook. 3 58 55 15 Ball Hook 88 84 23-206cm (81 1/4") 58-371cm (146 1/4") 72-603cm (237 1/2") 78-160cm (63 1/8") 11