Weider Tech 8.5 Bench English Manual - Page 6

ASSEMBLY Make Assembly Easier Everything in this manual is designed to ensure that the weight bench can be assembled successfully by almost anyone. By setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • To hire an authorized service technician to assemble the weight bench, call 1-800-445-2480. • Assembly requires two persons. • Because of its size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight bench as you assemble it. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • For help identifying small parts, use the PART IDENTIFICATION CHART on pages 5. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. • Assembly requires the included hex key(s) and the following tools (not included): two adjustable wrenches one rubber mallet one standard screwdriver one Phillips screwdriver Assembly may be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before beginning assembly, read the impor- 1 tant information in the box above. See the PART IDENTIFICATION CHART on page 5 for help identifying small parts. Attach the two Bench Stabilizer Plates (127) to the Bench Stabilizer (108) with four M4 x 15mm Self-tapping Screws (95). 127 95 2. Attach the Bench Stabilizer (108) to the Bench 2 Frame (107) with two M8 x 75mm Carriage Bolts 124 (121) and two M8 Nylon Locknuts (84). Do not tighten the Nylon Locknuts yet. Next, tighten the Bench Knob (124) into the Bench Frame (107). 108 127 95 84 107 108 121 6