Weslo Cadence 45 User Manual - Page 7

2. See the inset drawing. Identify the Right Upright (37), which has a large round hole near the lower end, and the Left Upright (32). Have a second person hold the Base (55) so it is resting on the Wheels (34) as shown. Attach the Right and Left Uprights (32, 37) to the Base with four Upright Bolts (28), four 3/8" Star Washers (90), and four Upright Nuts (49). Do not tighten the Bolts yet. Make sure that the large hole in the Right Upright is in the indicated location, and that the two small holes in the Left Upright are in the indicated location. In addition, make sure that the Base is oriented so the Base Pads (31) are in the location shown. 2 28 90 Small Holes 32 28 90 28 90 Large Hole 49 55 28 90 49 31 37 49 31 34 Hole 34 37 3. With the help of a second person, place the Frame (21) between the Uprights (32, 37). Feed the Wire Harness (53) into the large round hole near the lower end of the Right Upright (37), and then pull the Wire Harness out of the upper end as shown. See drawing 3a. Raise the Uprights (32, 37) to the vertical position. Hold an Upright Spacer (58) against one side of the Frame (21) as shown. Insert a Frame Bolt (36) into the indicated hole in the Upright Spacer and the Frame. Next, tighten a Spacer Screw (40) into the Upright Spacer and the Frame. Remove the Frame Bolt. Repeat on the other side of the Frame. With the help of a second person, carefully lift the Frame (21), and hold the Upright Spacers (58) between the Right Upright (37) and the Left Upright (not shown). Align the indicated hole in the Right Upright with the hole in the right Upright Spacer. Next, insert a Frame Bolt (36) with a 3/8" Star Washer (90) into the Right Upright and the Upright Spacer, and loosely thread the Upright Bolt into the Frame. Repeat this step on the left side of the treadmill. 3 32 3a 40 58 21 Hole 21 53 37 53 37 90 36 Holes 4. With the help of a second person, raise the Left and 4 Right Uprights (32, 37) to the vertical position. 4 Feed the Wire Harness (53) into the hole in the bottom of 53 one of the Handrails (4) and out of the large hole in the side. Note: It may be helpful to use needlenose pliers to 44 Hole pull the Wire Harness out of the hole. Set the Handrail (4) onto the Right Upright (37). Attach 68 Bracket 44 the Handrail with two Handrail Bolts (44) and two 5/16" Star Washers (68). Firmly tighten the Bolts. 44 4 32 68 Attach the other Handrail (4) as described above. Note: There is not a wire harness on the left side. 44 37 7