Weslo Cadence 70e English Manual - Page 7

6. Hold the Console (11) near the Console Base (87). Touch the right Handrail (4) to discharge any static. Locate the two wires in the Wire Harness (53) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 6a. Connect the other two wires in the Wire Harness to the back of the Console (87) in the locations shown by the arrows in drawing 6. If the connectors do not fit together easily, rotate them and then connect them. 6 87 11 53 6a Tabs 4 7. Set the Console (11) in the Console Base (87). Make sure that no wires are pinched. Insert as much of the Wire Harness as possible (53) down the hole in the right Handrail (4). Securely tighten the plastic tie nearest the right Handrail. Pull any excess Wire Harness between the plastic ties tight and tighten the other plastic tie. Cut off the ends of the plastic ties. Cover the Wire Harness with the Wire Cover (10), and route the Wire Harness out of the hole in the side of the Wire Cover. Attach the Wire Cover to the back of the Console Base with two 3/4" Screws (5). Do not overtighten the Screws. Make sure that no wires are pinched before you attach the Console (11) to the Console Base (87). Tighten the remaining four 3/4" Screws (5) into the Console Base and the Console. Do not overtighten the Screws. 7 Ties 10 53 87 5 5 4 11 5 8. Attach the Storage Latch (66) to the left Upright (38) 8 with two 3/4" Screws (5). 38 66 5 9. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 7