Weslo Cadence C22 English Manual - Page 10
Note: Each - treadmill belt
View all Weslo Cadence C22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
1 Insert the key fully into the console. Inserting the key will not turn on the display. The display will turn on when the ON/RESET button is pressed or when the walking belt starts. Note: If you just installed batteries, the display will already be on. 2 Reset the console and start the walking belt. Turn the speed control to the reset position. Note: Each time the walking belt is stopped, the speed control must be turned to the reset position before the walking belt can be restarted. Reset Next, slowly turn the speed control until the walking belt begins to move at slow speed. Carefully step onto the walking belt and begin exercising. Change the speed of the walking belt as desired by turning the speed control. To stop the walking belt, step onto the foot rails and turn the speed control to the reset position. Note: The first time the treadmill is used, inspect the alignment of the walking belt, and align the walking belt if necessary (see page 13). 3 Follow your progress with the monitor modes When the power is turned on, the console will automatically scan through five modes. A flashing mode indicator will show which mode is currently displayed. The modes are described below. approximate number of fat calories you have burned. (See BURNING FAT on page 14.) • Calories (CALS)-This mode shows the approximate number of calories you have burned. If desired, reset the display by pressing the ON/RESET button. 4 When you are finished exercising, stop the walking belt and remove the key. Step onto the grip tape, stop the walking belt, and remove the key from the console. The display will turn off a few minutes after the key is removed. Note: The display will automatically turn off to conserve the batteries any time that the walking belt is stopped and the ON/RESET button is not pressed for a few minutes. HOW TO CHANGE THE INCLINE OF THE TREADMILL To vary the intensity of your exercise, the incline of the treadmill can be changed. There are three incline levels. Before changing the incline, remove the key and unplug the power cord. Next, fold the treadmill to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 11). To change the incline, remove the incline pin from one of the incline legs as shown below. Adjust the incline leg to the desired height and fully reinsert the incline pin. Make sure that the incline pin is in the "locked" position shown in the inset drawing. Adjust the other incline leg in the same way. Make sure that both incline pins are inserted from the direction shown. Incline Pin Incline Pin • Speed-This mode shows your speed, in miles per hour. Incline Pin • Time-This mode shows the elapsed time. Note: If you Mode Indicator stop exercising for ten seconds or longer, the time mode will pause. • Distance-This mode shows the total number of miles you have walked or run. • Fat Calories (FAT CALS)-This mode shows the CAUTION: Before using the treadmill, make sure that both incline pins are fully inserted at the same height. Do not use the treadmill with the incline pins removed. After you have adjusted the incline legs, lower the treadmill (see HOW TO LOWER THE TREADMILL FOR USE on page 11). 10