Weslo Cadence C32 Treadmill English Manual - Page 5

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires a phillips screwdriver needlenose pliers . , two adjustable wrenches , and 1. Note: To identify small parts used during assembly, 1 refer to the PART IDENTIFICATION CHART in the center of this manual. 46 ¥Hazardous Voltage ¥Risk of Electric Shock ¥Unplug Treadmill before Assembly /Disassembly. Attach four Base Pads (63) to the bottom of the Base (46) with four 3/4" Tek Screws (3). 63 3 63 3 2. Attach a Frame Spacer (27) to the left side of the Frame (79) with a Spacer Screw (89) as shown. Identify the Left Upright (53), which does not have a large round hole near the lower end. Hold the Left Upright so the indicated small hole is in the position shown. Loosely thread a Frame Bolt (70) with a Washer (66) and a Star Washer (29) through the Left Upright and the Frame Spacer (27) into the Frame (79) as shown. Do not tighten the bolts used in steps 2 through 5 until step 5 is completed. Refer to drawing 2b. Attach a Frame Spacer (27) to the right side of the Frame (79) with a Spacer Screw (89). Hold the Right Upright (62) so the indicated large hole is in the position shown. Insert the Wire Harness (60) into the large hole and out of the top of the Right Upright. Loosely thread a Frame Bolt (70) with a Washer (66) and a Star Washer (2) through the Right Upright (62) and the Frame Spacer (27) into the Frame (79). 2a 79 89 53 29 27 66 70 Small Hole 2b 27 79 89 62 29 66 60 Large 70 Hole 5