Weslo Cadence Dx12 Treadmill English Manual - Page 8
Caution
View all Weslo Cadence Dx12 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Monitor Display Speed Control Clip Note: If there is a thin sheet Key of clear plastic on the face of the console, remove it. Pulse Sensor Incline Control CAUTION: Before operating the console, read the following precautions. • Do not stand on the walking belt when turning on the power. • Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop. • Adjust the speed in small increments. • The training zones marked around the speed control are general guidelines only. See page 14 or more information. • To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle. BATTERY INSTALLATION STEP-BY-STEP CONSOLE OPERATION The console requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, open the battery cover as shown below. Press two batteries into the console, with the negative (-) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Be sure that the tab locks into place. Step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed. Follow the steps below and on page 9 to operate the console. Battery Cover Tab Batteries 1 Insert the key fully into the power switch. Inserting the key will not turn on the display. The display will turn on when the ON/RESET button is pressed or when the walking belt is started. (If you just installed batteries, the display will already be on.) 8