Weslo Cadence Sl 15 English Manual - Page 5

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included allen wrench and your own phillips screwdriver and adjustable wrench . Refer to the drawings below to identify the parts used in assembly. 3/4Ó Screw (55)Ð14 Handrail Bolt (15)Ð4 Extension Leg Screw (34)Ð2 Handrail Washer (16)Ð4 1. With the help of a second person, carefully raise the 1 Uprights (14), the Console Base (6), and the Right Handrail (57), until the treadmill is in the position shown. 6 Be careful not to pull on the Wire Harness (26). Refer to the inset drawing. Insert one of the Extension Legs (41) into the treadmill as shown. (Note: It may be helpful to tip the Uprights [14] in the direction shown by the arrow as you insert the Extension Leg. Make sure that the Base Pad [36] is on the bottom of the Extension Leg.) Attach the Extension Leg with an Extension Leg Screw (34). Be sure to push on the head of the Extension Leg Screw while tightening it. Attach the other Extension Leg (41) in the same way. 2. Without removing the tape from the Latch (12), attach the Latch to the left Upright (14) with four 3/4Ó Screws (55). Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape. Note: The inset drawing shows how the parts of the Latch (12) fit together. 2 14 12 55 26 57 14 Spacer 14 34 41 36 Springs Bracket Latch 5