Weslo Cadence Sl25 English Manual - Page 8

DIAGRAM OF THE CONSOLE LED Track Monitor Displays Incline Control Speed Control Clip Note: If there is a thin sheet of clear Key plastic on the console, remove it. CAUTION: Before operating the con- sole, read the following precautions. ¥ Do not stand on the walking belt when turning on the power. ¥ Adjust the speed in small increments. ¥ The training zones marked around the speed control are general guidelines only. See pages 14 and 15 for more information. ¥ Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop. ¥ To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Use only a sealed water bottle. STEP-BY-STEP CONSOLE OPERATION If there is a thin sheet of clear plastic on the face of the console, remove it. Next, make sure that the power cord is properly plugged in (see HOW TO PLUG IN THE POWER CORD on page 7). Be sure that the on/off switch near the power cord On Position is in the on position. Stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the steps below and on page 9 to operate the console. 1 Insert the key fully into the power switch. When the key is inserted, the first indicator in the LED track will light. The four displays will not turn on until the ON/RESET button is pressed or the walking belt is started. Note: If you just installed batteries, the displays will already be on. 8