Weslo Cadence Sl30 Treadmill English Manual - Page 5

ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench and your own phillips screwdriver , adjustable wrench , and scissors. 1. With the help of a second person, carefully raise the treadmill to the upright position. While the other person tips the treadmill to one side and holds it, insert an Extension Leg (59) into one side of the Base (32). Make sure that the Extension Leg is turned so the bracket is on the side shown. Using the Allen Wrench (102), tighten an Extension Leg Screw (57) into the Extension Leg and the Base. Attach the other Extension Leg in the same manner. 1 102 57 Bracket 32 59 2. Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill. Without removing the tape from the Latch (34), hold the Latch against the left Upright (32) as shown. Attach the Latch to the left Upright with four of the six Screws (33). Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape. Note: The inset drawing shows how the parts of the Latch (34) fit together. 3. Cut the plastic tie holding the cage nut in the upper end of the Left Handrail (60). Position the Left Handrail (60) against the left Upright (32) as shown. The bracket on the Extension Leg (59) should be inside of the lower end of the Left Handrail. Thread a Handrail Bolt (30) with a Handrail Washer (108) into the left Upright and the Left Handrail. Do not tighten the Handrail Bolt yet. 2 32 34 33 Spacer Springs 33 Latch Bracket 3 Plastic Tie 30 108 60 32 59 5