Weslo Cadence Sl30 English Manual - Page 10
The Information Mode
View all Weslo Cadence Sl30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
¥ DISTANCE/LAPS displayÑThis display shows the total distance that you have walked and the number of laps you have completed (one lap equals 1/4 mile). The display will alternate between one number and the other every seven seconds. The LAPS indicator will light when the number of laps is shown. ¥ TIME/PACE displayÑThis display shows the elapsed time and your current pace (pace is measured in minutes per mile). The PACE indicator will light when your pace is shown. Note: When a workout program is selected, the display will show the time remaining in the program. ¥ SPEED displayÑ This display shows the speed of the walking belt, in miles per hour or kilometers per hour. The KPH indicator will light when the speed is shown in kilometers per hour. To change the unit of measurement, hold down the START/STOP button while inserting the key into the console. An ÒEÓ for ÒEnglishÓ (miles per hour) or an ÒMÓ for ÒMetricÓ (kilometers per hour) will appear in the CALS/FAT CALS/PULSE display. Press the SPEED v button to change the unit of measurement. Remove and then reinsert the key. ¥ CALS/FAT CALS/ PULSE displayÑ This display shows the approximate numbers of calories and fat calories you have burned (see FAT BURNING on page 14). Every seven seconds, the display will change from one number to the other. The FAT indicator will light when the number of fat calories is shown. Note: This display will also show your heart rate when the pulse sensor is used (see step 7). 7 Measure your pulse, if desired. Stand on the foot rails and place your thumb on the pulse sensor as shown. The pulse sensor is pressure-acti- Pulse Sensor vatedÑfully press it down. (Do not press too hard, or the circulation in your thumb will be restricted, and your pulse Indicator will not be de- tected.) Next, raise your thumb slightly until the heart-shaped indicator by the CALS/FAT CALS/PULSE display flashes steadily and a ÒPÓ appears in the display. Hold your thumb at this level. After a few seconds, three dashes will appear in the display and your pulse will be shown. Hold your thumb on the sen- sor for another 15 seconds for the most accurate reading. If the displayed pulse appears to be too high or too low, or if your pulse is not displayed, lift your thumb off the sensor and allow the display to reset. Press down again on the sensor as described above. Make sure that your thumb is positioned as shown, and that you are applying the proper amount of pressure to the pulse sensor. Try the sensor several times until you become familiar with it. Remember to stand still while measuring your pulse. 8 When you are finished, remove the key. Step onto the foot rails and remove the key from the console. Store the key in a secure place. In addition, move the on/off switch to the off position. (See the drawing near the bottom of page 8.) THE INFORMATION MODE To access the consoleÕs information mode, hold down the START/STOP button while inserting the key into the console. An ÒEÓ for ÒEnglishÓ (miles per hour) or an ÒMÓ for ÒMetricÓ (kilometers per hour) will appear in the DISTANCE/LAPS display. Pressing the SPEED v but- ton will change the unit of measurement. The TIME/PACE display will show the total number of hours the treadmill has been used. The SPEED display will show the total number of miles accumulated on the treadmill. To exit the information mode, remove the key from the console. 10