Weslo Cardiostride 4.0 Treadmill English Manual - Page 15

Maintenance And Troubleshooting

Page 15 highlights

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE TROUBLESHOOTING Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the treadmill is used. Regularly clean the treadmill and keep the walking belt clean and dry. Wipe exterior parts of the treadmill with a damp cloth and a small amount of mild soap. IMPORTANT: Do not spray liquids directly onto the treadmill. To avoid damage to the console, keep liquids away from the console. Then, thoroughly dry the treadmill with a soft towel. LUBRICATING THE WALKING PLATFORM Before the treadmill is used, the walking platform should be lubricated. Open the included lubricant packet. Reach under one side of the walking belt as far as you can, and apply half of the lubricant to the walking platform. Then, reach under the other side of the walking belt and apply the remaining lubricant. After you have applied the lubricant, walk on the treadmill for a few minutes to spread the lubricant. Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual. SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY a. Replace the batteries in the console (see assembly step 8 on page 10). b. Look under the left side of the Frame (11) and locate the Reed Switch (15). Next, locate the Magnet (23) on the Flywheel (24). Turn the Flywheel until the Magnet is aligned with the Reed Switch. Move the Reed Switch so that there is a 1/8" (3 mm) gap between the Reed Switch and the Magnet. 11 24 23 15 1/8 in. View from below Apply lubricant here c. Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 9 on page 10). Apply lubricant here d. The console, like most electronics, is susceptible to static electricity build-up caused by certain types of clothing or by the operation of the treadmill. If the display is blank or gives incorrect readings, apply an anti-static spray to the handrail. Anti-static spray is available where laundry supplies are sold. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

15
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the treadmill is used.
Regularly clean the treadmill and keep the walking
belt clean and dry. Wipe exterior parts of the treadmill
with a damp cloth and a small amount of mild soap.
IMPORTANT: Do not spray liquids directly onto the
treadmill. To avoid damage to the console, keep
liquids away from the console.
Then, thoroughly dry
the treadmill with a soft towel.
LUBRICATING THE WALKING PLATFORM
Before the treadmill is used, the walking platform
should be lubricated.
Open the included lubricant
packet. Reach under one side of the walking belt as far
as you can, and apply half of the lubricant to the walk-
ing platform. Then, reach under the other side of the
walking belt and apply the remaining lubricant.
After
you have applied the lubricant, walk on the tread-
mill for a few minutes to spread the lubricant.
TROUBLESHOOTING
Most treadmill problems can be solved by follow-
ing the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: THE CONSOLE DOES NOT FUNCTION
PROPERLY
a.
Replace the batteries in the console (see assembly
step 8 on page 10).
b.
Look under the left side
of the Frame (11) and
locate the Reed Switch
(15). Next, locate the
Magnet (23) on the
Flywheel (24). Turn
the Flywheel until the
Magnet is aligned with
the Reed Switch.
Move
the Reed Switch so
that there is a 1/8" (3
mm) gap between the
Reed Switch and the
Magnet.
c.
Make sure that the handrail wire is plugged fully
into the wire on the console (see assembly step 9
on page 10).
d.
The console, like most electronics, is susceptible to
static electricity build-up caused by certain types of
clothing or by the operation of the treadmill. If the
display is blank or gives incorrect readings, apply
an anti-static spray to the handrail. Anti-static spray
is available where laundry supplies are sold.
MAINTENANCE AND TROUBLESHOOTING
23
24
15
1/8 in.
View from
below
11
Apply
lubricant
here
Apply
lubricant
here