Weslo Crosswalk 5.0t Treadmill English Manual - Page 8

3. Set the Right Handrail (33) on the console assembly. Make sure that the console wire is not pinched. Remove the tie from the bracket on the Right Handrail. If necessary, press the Cage Nut (110) back into place. Start an M5 x 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail (33), and then start two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm Screw and then tighten the two M4.2 x 19mm Screws; do not overtighten the Screws. Attach the Left Handrail (not shown) to the console assembly in the same way. Note: There is no wire on the left side. 3 Console Wire 110 Bracket Console Assembly 85 7 33 10 4. With the help of a second person, hold the console assembly near the Right Upright (54). Connect the Wire Harness (39) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. If there is a wire tie on the Wire Harness, remove the wire tie. Insert the connectors and the excess wire downward into the Right Upright (54). 4 39 Console Assembly Console Wire 54 Console Wire 39 5. Set the console assembly on the Uprights (53, 5 54). Make sure that no wires are pinched. Start four M8 x 15mm Bolts (8) with four M8 Star Washers (5) into the Uprights as shown. Do not tighten the Bolts yet. Console Assembly 8 5 54 8 5 53 8