Weslo Crosswalk 5.2t Treadmill English Manual - Page 19

TROUBLESHOOTING Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the back cover of this manual. SYMPTOM: The power does not turn on b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in. c. Remove the key from the console, and then reinsert it. a. Make sure that the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a properly grounded outlet (see page 12). Use only a surge suppressor that meets all of the specifications described on page 12. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets. b. After the power cord has been plugged in, make sure that the key is inserted into the console. d. If the treadmill still will not run, please see the back cover of this manual. SYMPTOM: The displays of the console do not function properly a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the three indicated M4.2 x 19mm Washer Head Screws (20) and the two M5.5 x 25mm Screws (25). Then, carefully remove the Motor Hood (65). c. Check the power switch located on the treadmill frame near the power cord. If the switch protrudes a as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in. 65 20 c 25 Tripped Reset SYMPTOM: The power turns off during use a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in. 19