Weslo Lyne 3500 Treadmill Uk Manual - Page 8

Console May Be Damaged When The Power

Page 8 highlights

5. Place the Left Handrail (56) on the Console Assembly (91). Attach the end of the ground wire from the Console Assembly to the indicated small hole in the Left Handrail with the Silver Ground Screw (8). Attach the Left Handrail (56) to the Console Assembly (91) with two Console Screws (4), a Crossbar Screw (5), and a Crossbar Star Washer (12). Be careful not to pinch the ground wire. 5 5 12 4 Small Hole 56 Ground Wire 8 91 6. Hold the Console Assembly (91) near the Right Upright (54). Touch the Right Handrail to discharge any static. Insert the end of the Wire Harness (98) into the hole in the bottom of the Right Handrail (55) and out of the large hole in the side. Next, insert the end of the Wire Harness through the two looped plastic ties. Press the end of the Wire Harness (98) into the indicated connector on the back of the Console Assembly (91). The end of the Wire Harness should slide easily into the connector and snap into place. If it does not, turn the end of the Wire Harness and try again. IF THE CONNECTOR IS NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. 6 54 Connector 91 98 Plastic Ties 55 98 7. Insert the slack in the Wire Harness (98) downward into the Right Upright (54). Then, tighten the two plastic ties 7 around the Wire Harness, and cut off the ends of the plastic ties. 54 98 Plastic Ties 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23

8
6.
Hold the Console Assembly (91) near the Right Upright
(54).
Touch the Right Handrail to discharge any static.
Insert the end of the Wire Harness (98) into the hole in
the bottom of the Right Handrail (55) and out of the
large hole in the side. Next, insert the end of the Wire
Harness through the two looped plastic ties.
Press the end of the Wire Harness (98) into the indi-
cated connector on the back of the Console Assembly
(91).
The end of the Wire Harness should slide easily
into the connector and snap into place.
If it does not,
turn the end of the Wire Harness and try again.
IF THE
CONNECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Plastic
Ties
Connector
91
55
98
54
5.
Place the Left Handrail (56) on the Console Assembly
(91). Attach the end of the ground wire from the Console
Assembly to the indicated small hole in the Left Handrail
with the Silver Ground Screw (8).
Attach the Left Handrail (56) to the Console Assembly
(91) with two Console Screws (4), a Crossbar Screw (5),
and a Crossbar Star Washer (12).
Be careful not to
pinch the ground wire.
12
91
4
5
56
8
Ground Wire
Small
Hole
6
5
98
7.
Insert the slack in the Wire Harness (98) downward into
the Right Upright (54). Then, tighten the two plastic ties
around the Wire Harness, and cut off the ends of the
plastic ties.
98
Plastic
Ties
54
7