Weslo Momentum 7.0 Ex Elliptical English Manual - Page 8

9. Apply a small amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal Arm (11) and a 9 Wave Washer (70) onto the axle. Next, slide an M10 Washer (35) onto an M10 x 25mm Patch Screw (22), and tighten the Patch Screw into the axle. Apply a small amount of grease to a Pedal Arm Bolt 5 Set (40) and to the surfaces of the Large Handlebar Bushings (60) in the left Handlebar Arm (5). Next, hold the lower end of the left Handlebar Arm inside of the bracket on the Left Pedal Arm (11). Attach the Left Pedal Arm to the left Handlebar Arm with the Bolt Set. Do not overtighten the Bolt Set; the Handlebar Arm must pivot freely. 60 Grease 60 Grease 16 Attach the Right Pedal Arm (not shown) to the right 40 side of the elliptical exerciser in the same way. See step 6. Tighten the M10 x 68mm Button Bolts (48) in the Upright (2). See step 7. Tighten the M6 x 36mm Button Bolts (50) in the Handlebar Arms (5). 40 11 70 22 35 10. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 8