Weslo Pro Crosswalk 14.2t Treadmill English Manual - Page 9
Upright Wire 63. Start both Screws,
View all Weslo Pro Crosswalk 14.2t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
4. Hold the Right Upright (76) against the Base (74). Be careful not to pinch the Upright Wire 4 (63). Insert a 3/8" x 3 1/4" Screw (2) with a 3/8" Star Washer (3) into the top hole in the Right Upright (76). Then, partially tighten the Screw into the Base (74). Partially tighten two more 3/8" x 3 1/4" Screws (2) with two 3/8" Star Washers (3) into the Right Upright (76) and the Base (74); do not fully tighten the Screws yet. Attach the Left Upright (not shown) in the same way. Note: There are no wires on the left side. 76 63 74 3 2 3 5. Identify the Left and Right Handrails (59, 64). Remove the four 5/16" x 3/4" Screws (5) and 5 four 5/16" Star Washers (6) from the bottoms 5, 6 and sides of each Handrail. Hold the Right Handrail (64) near the Right Upright (76). Insert the wire tie on the Upright 63 64 6 Wire (63) through the hole in the bottom and out of the hole in the side of the Right Handrail as shown. Then, pull the Upright Wire through the 5, 6 5 Right Handrail. 59 Attach the Right Handrail (64) to the Right 6 Upright (76) with two of the 5/16" x 3/4" Screws 6 5 (5) and two of the 5/16" Star Washers (6) that you just removed. Make sure not to pinch the 76 Upright Wire (63). Start both Screws, and 5 6 then tighten them. 5 Attach the Left Handrail (59) to the Left Upright (66) as described above. Note: There are no 66 wires on the left side. 9