Weslo Pursuit 4.0 Dx English Manual - Page 6

6. While another person holds the Upright (13) in the 6 position shown, connect the Extension Wire (40) to the Reed Switch Wire (43). Next, connect the Resistance Cable (19) to the Lower Cable (45) in the following way: • See drawing A. Pull up on the metal bracket on the Lower Cable (45), and insert the tip of the Resistance Cable (19) into the wire clip inside of the metal bracket as shown. • See drawing B. Firmly pull up the Resistance Cable (19) and slide it into the top of the metal bracket as shown. • See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together. 19 Push the Wires (40, 43) and the Cables (19, 45) down into the Frame (1), and insert the Upright into the 45 Frame. Be careful to avoid pinching the Wires and Cables. Attach the Upright to the Frame with three M8 42 x 15mm Button Screws (34) and three M8 Split Washers (42). 34 Be careful to avoid pinching the wires and cables. 13 40 43 42 34 1 7. Attach the Seat (12) to the Seat Post (5) with four M8 Split Washers (42) and four M8 Nylon Locknuts (10). Note: The Split Washers and Nylon Locknuts may be preattached to the underside of the Seat. A B Metal Bracket 19 45 7 C Metal 19 Bracket 45 12 5 42 10 42 10 6