Weslo Pursuit E21 English Manual - Page 6

1. Carefully slide the Upright (3) onto the Frame (1) while pulling the excess Reed Switch Wire (42) and Resistance Cable (31) up through the Upright. Attach the Upright with three M10 x 25mm Button Head Screws (53) and three M10 Split Washers (54). Be careful not to pinch the Reed Switch Wire or the Resistance Cable. 1 3 54 53 2. Insert the two Pulse Wires (69) up through the indi- 2 cated hole in the Upright (3). Attach the Handlebar (37) to the Upright with two M10 Split Washers (54) and two M10 x 25mm Button Head Screws (53). 3 3. Loosen the Frame Knob (29) on the right side of the 3 Frame (1). Slide out the Seat Frame (2) until it stops. Tighten the Frame Knob. 42 31 53 54 Be careful not 53 to pinch the Reed Switch 1 Wire or the Resistance Cable. Hole 69 37 54 54 53 29 1 4. The Console (33) requires two "AA" batteries (not 4 included); alkaline batteries are recommended. Open the battery door on the back of the Console. Press two batteries into the Console. Make sure that the negative (-) ends of the batteries are touching the springs. Close the battery door. Back of Console 2 33 Battery Door Batteries 6