Weslo Pursuit R 20 Bike Uk Manual - Page 6

4. While another person holds the Upright (2) in the position shown, connect the Upper Wire Harness (56) to the Reed Switch Wire (57). Next, connect the Resistance Cable (13) to the Lower Cable (58) in the following way: • See drawing A. Pull up on the metal bracket (A) on the Lower Cable (58), and insert the tip of the Resistance Cable (13) into the wire clip inside of the metal bracket. • See drawing B. Firmly pull the Resistance Cable (13) and slide it into the metal bracket (A) on the Lower Cable (58) as shown. • See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket (A) together. Carefully pull the excess Upper Wire Harness (56) out of the top of the Upright (2), push the excess Cables (13, 58) down into the Frame (1), and slide the Upright onto the Frame. Be careful to avoid pinching the Wires and Cables. Next, attach the Upright with four M8 x 15mm Button Screws (51) and four M8 Curved Washers (50). 4 Be careful to avoid pinching the wires and cables. 2 50 51 13 58 51 50 51 56 57 1 5. The Console (5) requires two 1,5V AA batteries; alkaline batteries are recommended. Remove the battery cover from the Console. Insert two batteries into the Console. Make sure that the batteries are oriented as shown by the markings inside the Console. Then, reattach the battery cover. A B A A 13 58 5 Batteries C 13 A 58 Battery Cover 5 6