Weslo Pursuit U30 Bike English Manual - Page 15
Maintenance And Troubleshooting
View all Weslo Pursuit U30 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild detergent. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 7 on page 8. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the left pedal, the upright covers, and the left shield must be removed. feedback. When the Reed Switch is correctly adjusted, reattach the left shield, the upright covers, and the left pedal. HOW TO ADJUST THE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the belt may need to be adjusted. See HOW TO ADJUST THE REED SWITCH at the left and remove the left pedal, the upright covers, and the left shield. To adjust the belt, you must also remove the right pedal and the right shield. Using an adjustable wrench, turn the right pedal counterclockwise and remove it. Then, remove the screws from the right shield. Note: One screw from the shield is shorter than the other screws. Make sure to note the correct location of the short screw. Then, carefully remove the right shield. Using an adjustable wrench, turn the left pedal clockwise and remove it. Next, remove the screws from the upright covers and the left shield. Note: One screw from the shield is shorter than the other screws. Make sure to note the correct location of the short screw. Then, carefully remove the upright covers and the left shield. 35 37 32 10 23 38 43 27 21 With the left shield removed, locate the Reed Switch (43). Turn the Crank (21) until the Magnet (38) is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 15mm Screw (27). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct Next, loosen, but do not remove, the M8 x 20mm Bolt (23). Loosen the M8 Locknut (10) on the Flywheel (37). Tighten the M6 Locknuts (32), one on each side of the Flywheel, until the Belt (35) is properly tightened. Then, tighten the M8 Locknut (10) and the M8 x 20mm Bolt (23). Finally, reattach the shields, the upright covers, and the pedals. 15