Weslo Vector 502 Uk Manual - Page 6

3. Slide the two slots in the Handlebar Clamp (42) onto the 3 two indicated tabs on the Upright (13). Lift the bottom of the Handlebar Clamp away from the Upright. Insert the Handlebar (15) between the Handlebar Clamp and the Upright. Centre the Handlebar and rotate it to the desired position. Tighten the Adjustment Handle (53) onto the Upright (13). Note: The adjustment handle works like a spanner. Turn the Handle counterclockwise, pull it away from the Upright, turn it clockwise, push it toward the upright, and then turn it counterclockwise again. 4. The Console (16) requires three "AA" batteries; alka- 4 line batteries are recommended. Insert three batteries into the Console. Make sure that the batteries are oriented as shown by the diagram inside the Console. 15 Tabs 42 13 53 Batteries 16 5. Hold the Console (16) near the Upright (13). Insert the console cable and the console wire into the indicated hole and down through the Upright. Attach the ground wire to the Upright with the Ground Screw (27). Insert the excess wire and cable into the Upright. Attach the Console (16) to the Upright (13) with four M5 x 12mm Screws (49). Be careful to avoid pinching the wires. 5 Ground Wire 27 49 Hole 49 16 Console Wire Console Cable 13 Be careful to avoid pinching the wires. 6