WestBend 55120 Instruction Manual - Page 15
Leaning, Offee, Enter
View all WestBend 55120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CLEANING YOUR 3 IN 1 COFFEE CENTER - GENERAL 1. Switch all switches to off, unplug from electrical outlet and allow the entire unit to cool completely before cleaning. 2. Remove and discard used espresso grounds and disposable filter containing used coffee grounds. Clean brewing head with a damp cloth. 3. Remove and clean the espresso filter holder, filter cup, brew basket, overflow grid, grid base, carafes and covers in a solution of warm water and mild liquid soap. Rinse thoroughly and dry. 4. If there is water left in the boiler chamber or the coffee water reservoir, empty through the top opening of the unit by turning upside down. Note: Do not clean the inside of the water reservoir or boiler chamber with a cloth or paper toweling as this may leave particles in the chambers that may clog small openings in your coffeemaker. You only need to rinse with cold water periodically. 5. Remove rubber-frothing nozzle from the steam wand. Clean the frothing nozzle and the steam wand thoroughly with a solution of warm water and mild liquid soap. Rinse thoroughly and replace the rubber-frothing nozzle onto the steam wand. 6. The exterior of the Coffee Center can be wiped clean with a damp cloth. 7. Decalcify the 3 in 1 Coffee Center periodically. See the "Decalcifying Your 3 in 1 Coffee Center" section. CLEANING YOUR 3 IN 1 COFFEE CENTER - CLEANING THE STEAM NOZZLE • Milk residuals will build up in the tip of the steam nozzle after frothing milk. It is very important that after you remove the frothing nozzle, you wipe the steam nozzle clean with a damp cloth after each use. This will help prevent the steam nozzle from clogging and will ensure good frothing results. Should the steam nozzle become clogged, proceed as follows: 1. Ensure switches are off, unplugged from electrical outlet, all pressure has been released and the machine has cooled completely. 2. Remove the rubber frothing nozzle and the steam nozzle using the tool on the end of the coffee measure spoon provided with your machine. 3. Clean the nozzle with warm water and ensure the small hole in the end is clear. 4. Reattach the steam nozzle, tighten steam nozzle securely and slide the rubber- frothing nozzle onto the steam wand. 15