Western Digital WD100EB User Manual (pdf) - Page 9
Standard Jumper Settings - drive
View all Western Digital WD100EB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
WESTERN DIGITAL EIDE HARD DRIVE INSTALLATION GUIDE Standard Jumper Settings If you determine that your system does not support Cable Select or if you are uncertain, use the following information to properly jumper your new Western Digital EIDE hard drive. Note: Not all hard drive manufacturers use the same jumper configurations. If you are installing your new Western Digital hard drive along with a non-Western Digital hard drive, obtain jumper setting information from the original hard drive manufacturer. Single Configuration Single - Installing the new drive as the only drive in the system: If installing your new Western Digital hard drive as the only IDE device on the cable, no jumper shunt is necessary. Master/Slave Configuration To set up the Master/Slave configuration, one device on the cable must be jumpered as Master (primary device) and the other jumpered as Slave (secondary device). Master - Installing the new drive as the primary (bootable) drive: If installing your new Western Digital hard drive as the Master drive on the cable with two IDE devices, move the jumper shunt on the drive to pins 5 and 6. Configure the jumper on the other IDE device as Slave. Slave - Installing the new drive as the secondary drive: If installing your new Western Digital hard drive as the secondary drive on the cable with two IDE devices, move the jumper shunt on the drive to pins 3 and 4. If necessary, configure the jumper on the other IDE device as Master. CSEL INSTALL THE HARD DRIVE - 5