Western Digital WD1200JB User Manual (pdf) - Page 10
Connect the Hard Drive - installation
UPC - 718037104522
View all Western Digital WD1200JB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Connect the Hard Drive WESTERN DIGITAL EIDE HARD DRIVE INSTALLATION GUIDE 1. Connect the IDE Interface Cable to the Hard Drive(s): a) If installing the hard drive as the only drive on the cable: Connect the black connector of the IDE interface cable to the drive. b) If installing two drives on the same IDE interface cable: Configure the primary (bootable) drive as Master and the other drive as Slave; then connect the Master drive to the black connector of the IDE interface cable and the Slave drive to the gray connector. 2. Connect the IDE Interface Cable to the Motherboard: Attach the blue end of the IDE interface cable to the 40-pin connector on the motherboard. Match pin 1 on the IDE interface cable to the connector on the motherboard. Pin 1 Motherboard Interface cable from hard drive 3. Connect the Power Supply Cable: Attach the computer system power supply cable to the 4-pin power connector on the back of your new Western Digital hard drive. The pin connector is keyed to ensure proper insertion. INSTALL THE HARD DRIVE - 6