Whirlpool ED5DHEXWQ Dimension Guide - Page 1

Whirlpool ED5DHEXWQ Manual

Page 1 highlights

® Side by Side Refrigerator PRODUCT MODEL NUMBERS ED2CHQXT ED5CHQXT ED2CHQXV ED2DHEXW ED5DHEXW ED2FHEXV ED2KVEXV ED5FHEXV ED5FVGXW ED2HBEXT ED5HBEXT ED2HHEXT ED5HHEXT ED5HHGXT ED2JHEXT ED5JHEXT ED5KVEXV ED2LDEXW ED5LDEXW ED2LHEXT ED5LHEXT ED5PBEXT ED5VBEXT ED2VHEXT ED5VHEXT ED2VHEXV ED5VHEXV ED5CHQXV ED5GVEXV ED5PVEXV ED2GVEXV Electrical: A 115-Volt, 60-Hz., AC-only 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer control depending on the model) to the desired setting. Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required for the water dispenser and ice maker. IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa). If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa). LOCATION REQUIREMENTS PRODUCT DIMENSIONS D top of cabinet A not incl. handle 1 E overall Handle and door style will vary with model. C Dimensions "D" and "E" include rollers extended 3/4" (1.9 cm). B Model size 22 cu.ft. 25 cu.ft. Depth "A" 31-3/8" (79.7 cm) 31-3/8" (79.7 cm) Cab. Width Door Width Cab. Height "B" "C" "D" 32-3/4" 33-1/8" 65-7/8" (83.2 cm) (84.1 cm) (167.3 cm) 35-1/2" 35-7/8" 68-7/8" (90.2 cm) (91.1 cm) (174.9 cm) Overall Height "E" 66-3/4" (169.6 cm) 69-3/4" (177.2 cm) 1/2" (1.25 cm) To ensure proper ventilation for your refrigerator, allow for 1/2" (1.25 cm) space on each side and at the top. When installing your refrigerator next to a fixed wall, leave 2" (5.08 cm) minimum on each side (depending on your model) to allow for the door to swing open. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C). 2" (5.08 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. 2309541C 02-23-09

  • 1

Side by Side Refrigerator
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
ED2CHQXT
ED5CHQXT
ED2CHQXV
ED2DHEXW
ED5DHEXW
ED2FHEXV
ED2KVEXV
ED5FHEXV
ED5FVGXW
ED2HBEXT
ED5HBEXT
ED2HHEXT
ED5HHEXT
ED5HHGXT
ED2JHEXT
ED5JHEXT
ED5KVEXV
ED2LDEXW
ED5LDEXW
ED2LHEXT
ED5LHEXT
ED5PBEXT
ED5VBEXT
ED2VHEXT
ED5VHEXT
ED2VHEXV
ED5VHEXV
ED5CHQXV
ED5GVEXV
ED5PVEXV
ED2GVEXV
Electrical:
A 115-Volt, 60-Hz., AC-only 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate circuit
serving only your refrigerator be provided. Use an
outlet that cannot be turned off by a switch. Do not
use an extension cord.
NOTE:
Before performing any type of installation,
cleaning, or removing a light bulb, turn the control
(Thermostat, Refrigerator or Freezer control
depending on the model) to OFF and then
disconnect the refrigerator from the electrical
source. When you are finished, reconnect the
refrigerator to the electrical source and reset the
control (Thermostat, Refrigerator or Freezer
control depending on the model) to the desired
setting.
Water:
A cold water supply with water pressure
between 30 and 120 psi (207 and 827 kPa) is
required for the water dispenser and ice maker.
IMPORTANT:
The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 30 and 120 psi (207 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 2309541C
02-23-09
1
E
overall
D
top of
cabinet
C
B
not incl.
handle
A
Depth
Cab. Width
Door Width
Cab. Height
Overall Height
Model size
"A"
"B"
"C"
"D"
"E"
22 cu.ft.
31-3/8"
32-3/4"
33-1/8"
65-7/8"
66-3/4"
(79.7 cm)
(83.2 cm)
(84.1 cm)
(167.3 cm)
(169.6 cm)
25 cu.ft.
31-3/8"
35-1/2"
35-7/8"
68-7/8"
69-3/4"
(79.7 cm)
(90.2 cm)
(91.1 cm)
(174.9 cm)
(177.2 cm)
Handle and door style
will vary with model.
Dimensions “D” and “E”
include rollers extended
3/4" (1.9 cm).
®
LOCATION REQUIREMENTS
1
/
2
" (1.25 cm)
2" (5.08 cm)
To ensure proper ventilation for your refrigerator, allow for 1/2
(1.25 cm) space on
each side and at the top. When installing your refrigerator next to a fixed wall, leave
2
(5.08 cm) minimum on each side (depending on your model) to allow for the
door to swing open. If your refrigerator has an ice maker, allow extra space at the
back for the water line connections.
NOTE:
Do not install the refrigerator near an oven, radiator, or other heat source, nor
in a location where the temperature will fall below 55°F (13°C).