Whirlpool EED4300V User Instructions - Page 5

Dryercare

Get Whirlpool EED4300V PDF manuals and user guides View all Whirlpool EED4300V manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

[)G,@'i!!iii:iiiii!!c oii< Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for ordering information, please refer to the front page of your manual or contact the dealer from whom you purchased your dryer. 2. Put wet items on top of rack, leaving space between items. Do not allow items to hang over the edge of the rack. Close the door. 3. Select a timed drying cycle and temperature, or an air cycle. Items containing foam, rubber or plastic must be dried on a clothesline or by using an air cycle. Refer to the following table. NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack. To use the drying rack 4. Start the dryer. Reset cycle to complete drying, if needed. Rack Dry Cycle Temp Time 1. Place drying rack in dryer. Style 1: Your drying rack has front legs. Slide rear pegs into the dimples on the back wall of the dryer. Lower the front legs to rest on the dryer opening. Style 2: Your drying rack does not have front legs. Do not remove the lint screen. Slide drying rack over the bottom of the dryer door opening. Push down to secure rack on frame. Washable wool items (block Timed Low to shape, lay flat on rack) Stuffed toys/pillows (cotton Timed Low or polyester filled) Stuffed toys/pillows Foam rubber filled Air N/A (no heat) 60 min. 60 min. 90 min. DRYERCARE Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air. Every Load Cleaning 1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. Explosion Hazard Keep flammable materials and vapors, such as gasoine, away from dryer. Place dryer at least 18 inches (46 era) above the floor for a garage installation. Failure to do so can resumt in death, explosion, or Ire. Clean lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT: • Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics. • If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. 2. Push the lint screen firmly back into place. As Needed Cleaning 1. Roll lint off the screen with your fingers. 2. Wet both sides of lint screen with hot water. 3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 4. Rinse screen with hot water. 5. Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
[)G,@'i!!ii:ii
iiiiii!!c oii<
Use the Drying Rack to dry items such as sweaters
and pillows
without tumbling.
The drum
turns, but the rack does not move.
If your model does not have a drying rack, you may be able to
purchase one for your model. To find out whether your model allows
drying rack usage and for ordering information,
please refer to the
front page of your manual or contact the dealer from whom you
purchased your dryer.
NOTE: The rack must be removed
for normal tumbling.
Do not
use the automatic
cycle with the drying rack.
To use the drying rack
1.
Place drying rack in dryer.
Style
1: Your drying
rack has front legs. Slide rear pegs into
the dimples on the back wall of the dryer. Lower the front legs
to rest on the dryer opening.
Style 2: Your drying
rack does not have front legs. Do not
remove the lint screen. Slide drying rack over the bottom
of
the dryer door opening.
Push down
to secure
rack on frame.
2.
Put wet items on top of rack, leaving space between
items.
Do not allow
items to hang over the edge of the rack. Close
the door.
3.
Select a timed drying
cycle and temperature,
or an air cycle.
Items containing
foam, rubber
or plastic
must be dried on a
clothesline
or by using an air cycle. Refer to the following
table.
4.
Start the dryer. Reset cycle to complete
drying,
if needed.
Rack Dry
Cycle
Temp
Time
Washable wool items (block
Timed
Low
60 min.
to shape,
lay flat on rack)
Stuffed toys/pillows
(cotton
Timed
Low
60 min.
or polyester filled)
Stuffed toys/pillows
Air
N/A
90 min.
Foam rubber filled
(no heat)
DRYERCARE
Keep dryer area clear and free from items that would
obstruct
the
flow of combustion
and ventilation
air.
Explosion
Hazard
Keep flammable
materials
and vapors,
such
as
gasoine,
away from
dryer.
Place
dryer
at least
18 inches
(46 era) above
the floor
for a garage
installation.
Failure
to do so can
resumt in
death, explosion,
or Ire.
Clean lint screen before each load. A screen blocked
by lint can
increase drying time.
IMPORTANT:
•
Do not run the dryer with the lint screen loose, damaged,
blocked
or missing. Doing so can cause overheating
and
damage to both the dryer and fabrics.
•
If lint falls off the screen
into the dryer during removal, check
the exhaust
hood and remove the lint.
Every
Load
Cleaning
1.
The lint screen
is located on top of the dryer. Pull the lint
screen toward
you. Roll lint off the screen
with your fingers.
Do not rinse or wash screen to remove lint. Wet lint is hard to
remove.
2.
Push the lint screen firmly
back into place.
As Needed
Cleaning
1.
Roll lint off the screen with your fingers.
2.
Wet both sides of lint screen with hot water.
3.
Wet a nylon brush with hot water and liquid detergent.
Scrub
lint screen with the brush to remove residue buildup.
4.
Rinse screen with
hot water.
5.
Thoroughly
dry lint screen with a clean towel.
Replace screen
in dryer.