Whirlpool GEW9250PT Use and Care Guide - Page 17
Stopping Your Dryer, Pausing or Restarting, Control Locked, Loading, Drying and Cycle Tips
View all Whirlpool GEW9250PT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
To use a Manual Cycle s Rotate the dial to select a Manual Cycle. Press MORE TIME or LESS TIME until the desired drying time is displayed. Tap MORE TIME or LESS TIME and the time will change by 1-minute intervals. Press and hold MORE TIME or LESS TIME and the time will change by 5-minute intervals. The initial time displayed is the actual drying time. NOTE: The More Time or Less Time feature can be used only with Manual Cycles. s Press TEMPERATURE until the desired temperature glows. NOTE: Pressing the Dryness Level button will cause the triple beep indicating that this option is not selectable. Also, a Dryness Level is not indicated. s Press the WRINKLE SHIELD™ feature button if this option is desired. s Press the END OF CYCLE SIGNAL button to set volume to desired level. s Press (and hold) HOLD TO START button until dryer starts (about 1 second). While a Manual Cycle is running, you can change the settings for Time, Temperature, the WRINKLE SHIELD™ feature, and the cycle signals. Press the PAUSE/CANCEL key twice to stop the dryer and clear the settings, allowing you to select another cycle. Stopping Your Dryer To stop your dryer at any time Press PAUSE/CANCEL twice or open the door. Pausing or Restarting To pause the dryer at any time Open the door or press PAUSE/CANCEL once. To restart the dryer Close the door and press (and hold) HOLD TO START button until dryer starts. NOTE: Drying will continue from where the cycle was interrupted if you close the door and press Start within 5 minutes. If the cycle is interrupted for more than 5 minutes, the dryer will shut off. Select new cycle settings before restarting the dryer. Control Locked This feature allows you to lock your settings to prevent unintended use of the dryer. You can also use the Control Locked feature to prevent unintended cycle or option changes during dryer operation. To enable the Control Locked feature when dryer is running: Press and hold the END OF CYCLE SIGNAL button for 3 seconds. The control is locked when a single beep is heard and the Control Locked status light is on. s When the dryer is off, it is not necessary to press the Control On button before activating the Control Locked feature. To unlock: Press and hold the END OF CYCLE SIGNAL button for 3 seconds to turn this feature off. NOTE: When the dryer is running and Control Locked is on, the dryer can be stopped by pressing the Pause/Cancel button, but can't be restarted until the control is unlocked. Loading Properly loading your dryer can lower your utility bill and prolong the life of your garments. Loading suggestions s Load the dryer by the amount of space items take up, not by their weight. s Do not overload the dryer. This causes wrinkling and uneven drying. Super Capacity Plus Dryers Heavy Work Clothes 4 jeans 4 workpants 4 workshirts Towels 10 bath towels 10 hand towels Mixed Load 3 sheets (1 king, 2 twin) 4 pillowcases 3 shirts 3 blouses 2 sweatpants 2 sweatshirts 14 washcloths 9 T-shirts 9 shorts 10 handkerchiefs Drying and Cycle Tips Select the correct cycle and dryness level or temperature for your load. If an Automatic Cycle is running, the display shows the estimated cycle time when your dryer is automatically sensing the dryness level of your load. If a Manual Cycle is running, the display shows the exact number of minutes remaining in the cycle. Cool Down tumbles the load without heat during the last few minutes of all cycles. Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool Down depends on the load size and dryness level. Drying tips s Follow care label directions when they are available. s If desired, add a fabric softener sheet. Follow package instructions. s Remove the load from the dryer as soon as tumbling stops to reduce wrinkling. This is especially important for permanent press, knits, and synthetic fabrics. s Avoid drying heavy work clothes with lighter fabrics. This could cause overdrying of lighter fabrics, leading to increased shrinkage or wrinkling. s If you dry sheets in a mixed load or large items in the "Bulky Items" cycle, rearrange the load halfway through the dryer cycle. This will aid in the drying process. 17