Whirlpool GGE390LXB Installation Instructions - Page 3

Product Dimensions A* Cabinet Dimensions Cabinet opening dimensions shown are for 25" (63.5 cm) B** countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. A freestanding range may be installed next to combustible walls with zero clearance. B D C C* A E D F E*** J G I F H A. 35 90.8 cm ± 0.3 cm) cooktop height (minimum) with leveling legs screwed all the way in* B. Model/serial/rating plates (located behind the control panel)** C. 47 119.7 cm ± 0.3 cm) overall height (minimum) with leveling legs screwed all the way in* D. 28 72.4 cm ± 0.6 cm) depth with handle E. 26 66.4 cm ± 0.3 cm)*** F. 29 76.0 cm ± 0.2 cm) width *Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. **Model/serial/rating plates may be rotated up from behind the control panel for viewing from the front of the range. ***Excludes handle. Dimension given is from wall to front of oven door and will vary based on electric outlet receptacle installation. K A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33.0 cm) upper cabinet depth C. 30" (76.2 cm) min. opening width. D. For minimum clearance to the top of the cooktop, see NOTE. E. 30" (76.2 cm) min. opening width F. Cabinet door or hinge should not extend into cutout* G. 1½" (3.8 cm) min. from right side cabinet H. 2" (5.1 cm) min. from floor I. 7" (17.8 cm) min. from floor J. 8" (20.3 cm) width K. 3½"(8.91 cm) min. from floor Proper positioning of outlet shown above. *Nothing located in shaded areas can extend more than 1½" (3.8 cm) from wall or range will not slide all the way back. NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet. 3