Whirlpool GI15NDXZB Use & Care Guide - Page 9
Door Reversal-Side Swing Only
View all Whirlpool GI15NDXZB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Side View Connecting the Drain After ensuring that the drain system is adequate, follow these steps to properly place the ice maker: 1⁷⁄₈" (4.8 cm) A B 1" (2.54 cm) WARNING 23" C (58.4 cm) D 2" - 1¹⁄₂" (5 cm - 3.8 cm) A. Drain hose B. 1" (2.54 cm) air gap C. PVC drain reducer D. Center of drain should be 23" (58.4 cm) from front of door, with or without the ³⁄₄" (1.91 cm) panel on the door. The drain should also be centered from left to right (7 18.56 cm] from either side of the ice maker). Drain Pump System (on some models) IMPORTANT: ■ Connect the ice maker drain to your drain in accordance with the International Plumbing Code and any local codes and ordinances. ■ The drain pump discharge line must terminate at an open sited drain. ■ Maximum rise 10 ft (3.1 m) ■ Maximum run 100 ft (30.5 m) NOTES: ■ If the drain hose becomes twisted and water cannot drain, your ice maker will not work. ■ It may be desirable to insulate the drain line thoroughly up to the drain inlet. An Insulation Sleeve kit, Part Number W10365792, is available for purchase. ■ Do not connect the outlet end of the drain tube to a closed pipe system to keep drain water from backing up into the ice maker. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. WARNING Excessive Weight Hazard Use two or more people to move and install ice maker. Failure to do so can result in back or other injury. 2. Style 1-For gravity drain system, push the ice maker into position so that the ice maker drain tube is positioned over the PVC drain reducer. See "Gravity Drain System." Style 2-For drain pump system connect the drain pump outlet hose to the drain. See "Drain Pump System." 3. Recheck the ice maker to be sure that it is level. See "Leveling." 4. If it is required by your local sanitation code, seal the cabinet to the floor with an approved caulking compound after all water and electrical connections have been made. Door Reversal-Side Swing Only Tools Needed Gather the required tools and parts before starting installation. wrench ■ Flat putty knife wrench ■ Phillips screwdriver Hinge pin Handle screw hex-head hinge screw End cap screw 9