Whirlpool GI7FVCXXQ Owners Manual - Page 12

Ice Maker and Storage Bin IMPORTANT: ■ Flush the water system before turning on the ice maker. See "Water and Ice Dispensers." ■ The ice maker and storage bin are located in the upper lefthand side of the refrigerator compartment. Turning the Ice Maker On/Off Your ice maker has an automatic shutoff. When the ice maker is on, sensors will automatically stop ice production when the storage bin is full. The ice maker will remain set to ON, and ice production will resume when the bin is no longer full. To manually turn off the ice maker, press the ice maker icon or OPTIONS on the main display screen, then ICE MAKER. On the next screen, press ICE MAKER again to toggle between ON and OFF. When the ice maker is set to OFF, it will stop producing ice. Removing and Replacing Ice Storage Bin To Remove the Ice Storage Bin: NOTE: It is not necessary to turn off the ice maker when removing the storage bin. 1. Pull the handle to unlock the ice storage bin. 2. Hold both sides of the ice storage bin, tilt the bin forward and lift slightly to remove. To Replace the Ice Storage Bin: IMPORTANT: The ice storage bin must be locked in place for proper ice dispensing. 1. Replace the ice storage bin on the door. 2. Pivot the bin so that it is firmly in place, and push back to assure that it is secure. Ice Production Rate ■ Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. ■ The ice maker should produce approximately 40 batches of ice in a 24-hour period. ■ To increase ice production, lower the freezer and refrigerator temperature. See "Using the Controls." Wait 24 hours between adjustments. Remember ■ The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained. ■ Do not use anything sharp to break up the ice in the bin. This can cause damage to the ice bin and dispenser mechanism. ■ Do not store anything on top of the ice maker or in the ice storage bin. Water Filter Status Light The water filter status light will help you know when to change your water filter. When the water filter status display changes from "NORMAL" to "ORDER," this tells you that it is almost time to change the water filter cartridge. Replace the water filter cartridge when the water filter status display changes to "REPLACE." If water flow to your water dispenser or ice maker decreases noticeably, change the filter sooner. The filter should be replaced at least every 6 months depending on your water quality and usage. To change the filter, see "Water Filtration System." INDICATOR: STATUS: NORMAL (green) New filter installed ORDER (yellow) Order filter REPLACE (red) OR when water flow decreases Replace water filter After changing the water filter, reset the status light. On the display screen, press OPTIONS, then WATER FILTER, then RESET, then YES. The status light will change from REPLACE (red) to NORMAL (green) when the system is reset. Water Filtration System The water filter is located in the upper right-hand corner of the refrigerator compartment. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. IMPORTANT: The disposable water filter should be replaced at least every 6 months. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter more often. Replacing the Water Filter To purchase a replacement water filter, Part Number UKF8001AXX-200, contact your dealer or call 1-800-253-1301 in the U.S.A. or 1-800-807-6777 in Canada. IMPORTANT: Air trapped in the water system may cause water and filter to eject. Always dispense water for at least 2 minutes before removing the filter or blue bypass cap. 1. To access the filter, press upward on the ribbed section of the water filter cover. 2. Turn filter counterclockwise to remove. 3. Remove sealing label from replacement filter and insert the filter end into the filter head. 4. Turn the filter clockwise until it stops. Snap the filter cover closed. 5. Flush the water system. See "Water and Ice Dispensers." NOTE: The dispenser feature may be used without a water filter installed. Your water will not be filtered. If this option is chosen, replace the filter with the blue bypass cap. 12