Whirlpool GJC3634RP Installation Instructions - Page 4
Prepare Cooktop
UPC - 050946997001
View all Whirlpool GJC3634RP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
It is not recommended to ground to a gas pipe. Check with a qualified electrical installer if you are not sure the cooktop is properly grounded. It is not recommended to have a fuse in the neutral or ground circuit. Make sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. O-M91-latest edition, and all local codes and ordinances. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 Before You Make the Electrical Connection: To properly install your cooktop, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. I A 4-wire or 3-wire, single phase, 240 volt, 60 Hz., AC only electrical supply is required on a separate, 40-amp circuit, fused on both sides of the line. Cooktops with 3-wire cable coming from the cooktop are rated 240 volt and do not have a neutral (white) wire. NOTE: The 15" (38.1 cm) model series requires a 20-amp circuit. I The cooktop should be connected directly to the junction box through flexible, armored or nonmetallic sheathed, copper cable. The flexible, armored cable extending from the fuse box or circuit breaker box should be connected directly to the junction box. I Locate the junction box to allow as much slack as possible between the junction box and the cooktop so that the cooktop can be moved if servicing becomes necessary in the future. I Do not cut the conduit. The length of conduit provided is for serviceability of the cooktop. I A UL listed or CSA approved conduit connector must be provided at each end of the power supply cable (at the cooktop and at the junction box). A listed conduit connector is already provided at the cooktop. I If the house has aluminum wiring, follow the procedure below: 1. Connect a section of solid copper wire to the pigtail leads. 2. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Prepare Cooktop WARNING Excessive Weight Hazard Use two or more people to move and install cooktop. Failure to do so can result in back or other injury. 1. Decide on the final location for the cooktop. 2. Remove foam strip from literature packing. Remove backing from foam strip. Apply foam strip adhesive-side down around bottom of cooktop, flush with edge. NOTE: The foam strip protects the underside of the cooktop glass from debris and helps the cooktop sit flat on uneven counters. A B C A. Cooktop base B. Foam strip C. Glass 4