Whirlpool GSC308PRQ Installation Instructions - Page 1

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY (a) Do not attempt to operate this oven with the door open since open-door operation can result in harmful exposure to microwave energy. It is important not to defeat or tamper with the safety interlocks. (b) Do not place any object between the oven front face and the door or allow soil or cleaner residue to accumulate on sealing surfaces. (c) Do not operate the oven if it is damaged. It is particularly important that the oven door close properly and that there is no damage to the: (1) Door (bent), (2) Hinges and latches (broken or loosened), (3) Door seals and sealing surfaces. (d) The oven should not be adjusted or repaired by anyone except properly qualified service personnel. INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Tools needed s Phillips screwdriver Parts needed s A UL listed or CSA approved conduit connector s UL listed wire nuts Parts supplied s 2 screws (single oven) or 4 screws (double oven) Check local codes. Check existing electrical supply. See "Electrical Requirements." All electrical connections should be made by a licensed, qualified electrical installer. Location Requirements Make sure you have everything needed for correct installation. It is the responsibility of the installer to comply with the installation clearances specified in these instructions. IMPORTANT: Observe all governing codes and ordinances. Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven. s Recessed installation area must provide complete enclosure around the recessed portion of the oven. s Grounded electrical supply is required. See "Electrical Requirements" section. s Electrical supply junction box should be located 3" (7.6 cm) maximum below the support surface when the oven is installed in a wall cabinet. Drill a 1" (2.5 cm) minimum diameter hole in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. s Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a total weight (microwave and built-in oven) of 238 lbs (108 kg). Product Dimensions 27" (68.6 cm) and 30" (76.2 cm) Ovens A B E D C 27" (68.6 cm) models A. 25³⁄₈" (64.5 cm) recessed width B. 42 107.8 cm) overall height C. 26³⁄₄" (67.9 cm) overall width D. 23" (58.4 cm) max. recessed depth E. 41" (104.1 cm) recessed height 30" (76.2 cm) models A. 28³⁄₈" (71.2 cm) recessed width B. 42 107.8 cm) overall height C. 29³⁄₄" (75.6 cm) overall width D. 23" (58.4 cm) max. recessed depth E. 41" (104.1 cm) recessed height 2