Whirlpool GY397LXUQ Dimension Guide - Page 1

® 30" Slide-in Electric Range PRODUCT MODEL NUMBERS GY397LXU GY399LXU Electrical: This range is manufactured with the neutral terminal connected to the cabinet. Use a 3wire, UL listed, 40- or 50-amp power supply cord (pigtail) (see Range Rating chart below). If local codes do not permit ground through the neutral, use a 4-wire power supply cord rated at 250 volts, 40- or 50-amps and investigaed for use with ranges. A time-delay fuse or circuit breaker is recommended. The model/serial rating plate is located on the oven frame behind the storage drawer panel. Range Rating 120/240 Volts 8.8 - 16.5 KW 16.6 - 22.5 KW 120/208 Volts 7.8 - 12.5 KW 12.6 - 18.5 KW Specified Rating of Power Supply Cord Kit and Circuit Protection Amps 40 or 50 50 COUNTERTOP PREPERATION The cooktop sides of the slide-in range fit over the cutout edge of your countertop. If you have a square finish (flat) countertop and the opening width is 30" (76.2 cm), no countertop preparation is required. Formed front-edged countertops: Must have molded edge shaved flat 3/8" (1.0 cm) from each front corner of opening. Tile countertops may need trim cut back 3/8" (1.0 cm) from each front corner and/or rounded edge flattened. If countertop opening width is greater than 30" (76.2 cm), adjust the 3/8" (1.0 cm) dimension. Countertop must be level. Place level on countertop, first side to side; then front to back. If countertop is not level, range will not be level. Oven must be level for satisfactory baking conditions. OVERALL DIMENSIONS 30-3/4" (78.1 cm) cooktop width 35-3/4" (90.8 cm) cooktop height with leveling legs screwed all the way in 23-3/4" (60.3 cm) 1" (2.5 cm) spacer 28-5/16" (71.9 cm) depth with handle CABINET OPENING DIMENSIONS Cabinet opening dimensions shown are for: 25" (63.5 cm) countertop depth, 24" (61.0 cm) base cabinet depth, 36" (91.4 cm) countertop height 13" (33.0 cm) max. upper cabinet depth 30" (76.2 cm) min. cabinet opening width 29-7/8" (75.9 cm) width* *30-3/4" (78.1 cm) with side panels For minimum clearance to the top of the cooktop, see NOTE.* 23-1/4" (59.1 cm) opening depth 3/8" (9.5 cm) radius both corners 30" (76.2 cm) opening width** 30" (76.2 cm) opening width 3/8" (1.0 cm) 30-3/4" (78.1 cm) Formed or tiled countertop trimmed 1/2" (1.3 cm) back at front corners of countertop opening. junction box - 5.5" (14 cm min.) from either cabinet, 10" (25.4 cm) max. from floor. Cabinet door or hinge should not extend into cutout. *NOTE: 24" (61 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4" (6.4 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet. **30-7/8" (78.4 cm) with side panels. Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. 8101P750-60 04-09-08