Whirlpool IC14B Use & Care Guide - Page 5

7. Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the end of the tubing into the outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten. 8. Place the free end of the tubing in a container or sink, and turn ON the main water supply. Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe. Coil the copper tubing. Connect to Refrigerator NOTE: On kit models, assemble water valve to refrigerator according to kit instructions. Style 1 1. Unplug refrigerator or disconnect power. 2. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. 3. Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall. 4. Turn shutoff valve ON. 5. Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak. A B C D E A. Tube clamp B. Tube clamp screw C. Copper tubing D. Compression nut E. Valve inlet 6. The ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer. Style 2 1. Unplug refrigerator or disconnect power. 2. Disconnect the tube clamp on the back of the product and insert the copper tubing through the clamp as shown. 3. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. 4. Tighten the compression nut. Do not overtighten. Reattach the tube clamp and tube to the back of the cabinet. 5. Turn shutoff valve ON. Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak. 6. The ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer. Complete the Installation WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill ice container. Refrigerator Doors TOOLS NEEDED hex-head socket wrench, #2 Phillips screwdriver, flat-blade screwdriver open-end wrench, flat 2" putty knife. IMPORTANT: ■ Before you begin, turn the refrigerator control OFF. Unplug refrigerator or disconnect power. ■ Remove food and adjustable door or utility bins from doors. ■ If you are only removing and replacing the doors, see the "Remove Doors and Hinges" and "Replace Doors and Hinges" sections. Remove Doors and Hinges Hex-Head Hinge Screw A B 1. Unplug refrigerator or disconnect power. 2. Close the refrigerator door and keep both doors closed until you are ready to lift them free from the cabinet. NOTE: Provide support between the freezer and refrigerator doors while the hinges are being moved. Do not depend on C the door magnets to hold the doors in place while you are working. 3. Remove the parts for the top hinge as shown in Top Hinge graphic. Lift the freezer door free from the cabinet. A. Tube clamp C. Compression nut B. Copper tubing 5