Whirlpool LGQ8000JQ User Instructions - Page 5
Dryercare
View all Whirlpool LGQ8000JQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
UsetheDryingRacktodryitemsuchassweatearsndpillows withoutut mblingT.hedrumturnsb, uttherackdoesnotmove. Ifyourmodedloesnothaveadryinrgacky, oumaybeableto purchasoeneforyoumr odeTl.ofindoutifyoumr odealllowdsrying rackusagaendfororderinignformatiopnle, asreefetrothefront pageofyourmanuoarlcontactht edealefromwhomyou purchaseyodudr ryer. NOTET:herackmusbt eremovefdornormatul mblingD.onot usetheautomatcicyclewiththedryingrack. To use the drying rack 1. Slide rear pegs into the dimples on the back wall of the dryer. Lower the front legs to rest on the dryer opening. 2. Put wet items on top of rack, leaving space between items. Do not allow items to hang over the edge of the rack. Close the door. 3. Select a timed drying cycle and temperature, or an air cycle. Items containing foam, rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the following table. 4. Start the dryer. Reset cycle to complete drying, if needed. Rack Dry Cycle Temp Time Washable wool items (block Timed Low 60 min. to shape, lay flat on rack) Drying Stuffed toys/pillows (cotton Timed Low 60 min. or polyester filled) Drying Stuffed toys/pillows Foam rubber filled Air N/A (no heat) 90 min. DRYERCARE Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air. Style 2: 1. The lint screen is located in the door of the dryer. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 2. Push the lint screen firmly back into place. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer, Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. Clean the lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT: • Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. • If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. Every Load Cleaning Style 1: 1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 2. Push the lint screen firmly back into place. As Needed Cleaning 1. Roll lint off the screen with your fingers. 2. Wet both sides of lint screen with hot water. 3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 4. Rinse screen with hot water. 5. Thoroughly dry lint screen with a clean towel. Replace screen in dryer. 1. Apply a non-flammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed. 2. Wipe drum thoroughly with a damp cloth. 3. Tumble a load of clean cloths or towels to dry the drum. NOTE: Garments which contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside-out to prevent dye transfer. From Inside the Dryer Cabinet Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person. From Inside the Exhaust Vent Lint should be removed every 2 years, or more often, depending on dryer usage.