Whirlpool MH1160XSB Installation Instructions - Page 9

5.

Cut the 11/2"(3.8 cm) diameter

hole at the circular shaded area

"G" on the template.

This hole is for the power supply

cord.

NOTE: If upper cabinet

is metal, the supply

cord bushing

needs to

be installed

around the supply

cord hole, as shown.

A

......................................................

f

A. Metal cabinet

B. Power

supply cord

bushing

6.

Drill 3/8" (10 mm) holes at points "D" and "E" on the template.

These are for two 1/4-20 x 3" flat-head

bolts and washers

used to secure the microwave

oven to the upper cabinet.

For Roof Venting

Installation

Only

7.

Cut 3/4" (19 mm) hole at one corner of the shaded rectangular

area "F" on Upper Cabinet Template.

8.

Using a keyhole saw, cut out the rectangular

area.

1.

2.

D(,smpe Assemby

(f<';;_/'

w<x v®s'_n{_ o_'sy}

Check that damper

blade moves freely, and opens fully.

Position the damper

assembly

on the back of the microwave

oven so that the damper

blade hinge is at the top, and the

damper

blade opens away from the microwave

oven,

A

B

C

D

ns xs

the Mc

o7

'eOven

Excessive

Weight

Hazard

Use two or more people to move and install

microwave

oven.

Failure to do so can result in back or other injury.

IMPORTANT:

The control

side of the microwave

oven is the heavy

side. Handle the microwave

oven gently.

1.

Place a washer on each 1/4-20 x 3" flat-head

bolt and place

inside upper cabinet

near the 3/8" (10 mm) holes.

2.

Make sure the microwave

oven door is closed

and taped shut.

II

l

3.

Using 2 or more people, lift microwave

oven and hang it on

support

tabs at the bottom

of mounting

plate.

NOTE: Do not grip or use the door or door handle during

installation.

A. Back of microwave

oven

B. Damper

assembly

C. Damper

blade

D. Sheet metal screws

'L

3.

Secure damper

assembly

with 2 sheet metal screws.

4.

A

IL

B

A. Mounting

plate

B. Support

tabs

With front of microwave

oven still tilted, thread power

supply

cord through

the power supply

cord hole in the bottom

of the

upper cabinet.

\

5.

Rotate microwave

oven up toward

upper cabinet.

NOTE: If venting through

the wall, make sure the damper

assembly

fits easily into the vent tube in the wall cutout.

6.

Push microwave

oven against mounting

plate and hold in

place.

Whirlpool MH1160XSB Installation Instructions - Page 9

D,smpe Assemby, ns xs, the Mc, eOven - weight

Page 9 highlights