Whirlpool MH1170XS Installation Instructions - Page 6
Whirlpool MH1170XS Manual
View all Whirlpool MH1170XS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Locate Wall Stud(s) NOTE: If no wall studs exist within the cabinet opening, do not install the oven. See illustrations in "Possible Wall Stud Configurations." 1. Using a stud finder, locate the edges of the wall stud(s) within the opening. 2. Mark the center of each stud, and draw a plumb line down each stud center. See illustrations in "Possible Wall Stud Configurations." Possible Wall Stud Configurations These depictions show examples of preferred installation configurations with the mounting plate. No Wall Studs at Corner Holes Figure 1 No Wall Studs at Corner Holes Figure 2 A MOUNTING PLATE MOUNTING PLATE A A MOUNTING PLATE MOUNTING PLATE A B C C D C D A E B A E F A E F A E NOTE: If wall stud is within 6" (15.2 cm) of the vertical centerline (see "Mark Rear Wall" section), only recirculation or roof venting installation can be done. One Wall Stud at Two Corner Holes Figure 3 Wall Studs at All Four Corner Holes Figure 4 A MOUNTING PLATE MOUNTING PLATE A,D A,D MOUNTING PLATE MOUNTING PLATE A,D B D B A E C F A,D A,D E C E C F A,D E C A. Corner holes (on mounting plate) B. Cabinet opening vertical centerline C. Wall stud centerlines D. Holes for lag screws E. Support tabs F. Mounting plate center markers 6