Whirlpool MH1170XSB Use and Care Guide - Page 15
Remove, Replace, Grease, Filters, Filter, To Replace - installation instructions
View all Whirlpool MH1170XSB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2. Tip the vent grille forward and down, then lift to remove. The grease filters should be removed and cleaned at least once a month. Do not operate the microwave oven or exhaust fan without the grease filters in place. The charcoal filters cannot be washed and should be replaced every 6 to 12 months. See "General Cleaning" for cleaning instructions. See "Assistance or Service" to reorder filters. To Remove and Replace Grease Filters: 1. Remove each grease filter by sliding filter to the end. Pull tab down until the filter drops out. 3. Slide filter back slightly, lift front end, and pull out filter. A. Tabs 2. Replace grease filter by inserting one end of the filter into the outer end of the frame. Swing the other end up and slide into position. To Remove and Replace Charcoal Filter: 1. Remove the 2 vent grille mounting screws located directly behind the top louver. AB 4. Install new charcoal filter. 5. Replace vent grille and mounting screws. The cooktop light is a candelabra base bulb. See "Assistance or Service" section to reorder. To Replace: 1. Unplug microwave oven or disconnect power. 2. Remove the bulb cover mounting screw. A. Vent grille B. Top louver C. Mounting screws A. Mounting screw 3. Replace light. Close bulb cover. Replace mounting screw. 4. Plug in microwave oven or reconnect power. 15