Whirlpool MT4155SPS Installation Instructions - Page 4

2. Peel off backing of double-sided tape. Align the duct assembly screw hole to the existing screw hole on left side of microwave oven, and attach the duct assembly to the oven. Press down firmly on ducts, then fasten with existing screw. Microwave Oven Placement 1. Slide microwave oven partway into cutout opening. NOTE: Bottom bracket must be flat against cutout floor in order to correctly engage with anti-tip bracket. A A A. Existing screw Anti-Tip Bracket Installation 1. On cutout floor, use template to mark hole centers for anti-tip bracket. Be sure to align the centerline of template to centerline of cutout floor. (Dimensions as shown are not to scale.) AB C D B C A. Bottom duct B. Anti-tip bracket C. Bottom bracket 2. Plug in microwave oven. 3. Make sure microwave oven is centered within cutout opening and slide it into place, engaging anti-tip bracket. 4. Drill pilot holes through positioning flange. (Use drill.) Then install three ¹⁄₂" screws at front of bottom duct. A E F A. 1¹⁄₂" (3.81 cm) B. 3" (7.62 cm) C. 16" (40.64 cm) D. Cutout opening E. Cutout floor F. Centerline 2. Drill 2 holes for anti-tip bracket. (Use drill.) 3. Install anti-tip bracket onto cutout floor using two ¹⁄₂" screws. A B C A. Cutout opening B. Positioning flange C. ¹⁄₂" screws B A. ¹⁄₂" screws B. Anti-tip bracket 4